????

Your IP : 3.149.24.115

Current Path : C:/Windows/System32/drivers/en-US/

Current File : C:/Windows/System32/drivers/en-US/bthport.sys.mui

MZ����@��� �!�L�!This program cannot be run in DOS mode.

$��<߱�R���R���R�U�����R�U�P���R�Rich��R�PEL�!J

p��@ �G8.rdata�@@.rsrcP H@@ҝ�z
T88ҝ�z$��8.rdata8x.rdata$zzzdbg �.rsrc$01� �F.rsrc$02 �z(:����,wҁ��=�ʛ��Gҝ�z��(�@�X�p����� � � �� ���!xB�d��MUI���bf��ƞ��������R��A�.1)��mV���MUIen-US!00�@@�
@
@@@�@@,%@%@�PP������H��h ��
����x� ��"�"�(0�0��3�3�(������@ ���'.�.�d)6�:��)���*��,��.���/���2���3���4!�!�X6#�$��71�2�|;� �=Info

�The remote adapter %2 successfully paired with the local adapter.

�The remote adapter %2 was added to the list of personal devices.

�The remote adapter %2 is no longer a paired device. Its link key has been removed.

�The remote adapter %2 was removed from the list of personal devices.

�The remote adapter %2 is no longer a bonded device; attempted use of the link key resulted in a PIN code request.

@Windows cannot store Bluetooth authentication codes (link keys) on the local adapter. Bluetooth keyboards might not work in the system BIOS during startup.

�Your Bluetooth adapter does not support headset, hands-free, or any other SCO-based profiles.

�An incoming authentication request from a remote device %2 was rejected.

Information

�A command sent to the adapter has timed out. The adapter did not respond.

|Only one active Bluetooth adapter is supported at a time.

�A hardware error occurred. The event contains the vendor-specific error code.

�The local adapter returned an improper ACL data packet which was discarded.

A device with Bluetooth adapter address %2 has a bad service record (attribute identifier %3). The service will not be visible.

A device with Bluetooth adapter address %2 has a bad service record (attribute identifier %3). The attribute error was corrected.

�Windows rejected a device partnership because it is in a non bondable mode.

Windows rejected a device connection because the device didn't establish encryption prior to the service level connection.

The local adapter does not support a critical Low Energy feature, the Low Energy functionality will therefore be disabled.

�The local adapter does not support an important Low Energy controller state. The minimum required supported state mask is %2, got %3. Low Energy functionality is still enabled. This may increase power consumption.

|The local adapter does not support Bluetooth Low Energy.

�The Security Manager Protocol experienced a timeout waiting for a response from a remote device with address %2.

The local adapter does not support the minimum buffer requirement to support the hardware filtering of Bluetooth Low Energy advertisements. This may mean that your system will consume more power to process advertisements that are not intended for your system.

4Hardware Offload limit is reached by the Bluetooth controller. This may mean that any new pattern will not be monitored by the Bluetooth controller.

�The local adapter does not support an important Low Energy controller state to support peripheral mode. The minimum required supported state mask is %2, got %3. Low Energy peripheral role functionality will not be available.

0The local adapter does not support reading the encryption key size for a connected device. Insecure devices may be able to connect to this system.

�Windows dropped Active Peripheral Broadcast data from your Bluetooth device %2.

�A Bluetooth policy has changed. Policy %1\%2 has value of: %3

�Bluetooth radio enablement has been %3 due to policy %1\%2.

xBluetooth radio has %3 advertising due to policy %1\%2.

�Bluetooth radio has %3 discoverability due to policy %1\%2.

�Bluetooth radio has %3 radio name as %4 due to policy %1\%2.

dProcess %2 has attempted to pair to radio %1.

�Bluetooth has %1 service %2 on remote device %3 due to policy %4\%5...

�Bluetooth has %1 PSM %2 on remote device %3 due to policy %4\%5...

�A connection to a remote device %1 was successfully established.

pAn attempt to connect to a remote device %1 failed.

The minimum encryption key size requirement of %2 octets was enforced on a connection to the remote device %1. The key size is %3 octets.

HA connection to the remote device %1 was rejected because it did not meet the minimum encryption key size requirement of %2 octets. The key size was %3 octets.

0L2CAP_SIGNAL_REJECT

DL2CAP_SIGNAL_CONNECT_REQUEST

DL2CAP_SIGNAL_CONNECT_RESPONSE

@L2CAP_SIGNAL_CONFIG_REQUEST

DL2CAP_SIGNAL_CONFIG_RESPONSE

HL2CAP_SIGNAL_DISCONNECT_REQUEST

LL2CAP_SIGNAL_DISCONNECT_RESPONSE

<L2CAP_SIGNAL_ECHO_REQUEST

@L2CAP_SIGNAL_ECHO_RESPONSE

<L2CAP_SIGNAL_INFO_REQUEST

@L2CAP_SIGNAL_INFO_RESPONSE

4BRB_GET_LOCAL_BD_ADDR

HBRB_GET_LOCAL_SIGNAL_PARAMETERS

HBRB_GET_DEVICE_INTERFACE_STRING

0BRB_STORED_LINK_KEY

<BRB_L2CA_REGISTER_SERVER

@BRB_L2CA_UNREGISTER_SERVER

4BRB_L2CA_OPEN_CHANNEL

8BRB_L2CA_CLOSE_CHANNEL

8BRB_L2CA_UPDATE_CHANNEL

4BRB_L2CA_ACL_TRANSFER

<BRB_L2CA_CHANNEL_PROPERTY

$BRB_L2CA_PING

4BRB_L2CA_INFO_REQUEST

BRB_PSM

,BRB_ACL_GET_MODE

<BRB_ACL_ENTER_ACTIVE_MODE

<BRB_ACL_ENTER_SNIFF_MODE

8BRB_ACL_ENTER_PARK_MODE

8BRB_ACL_ENTER_HOLD_MODE

8BRB_ACL_ENHANCED_FLUSH

8Complete a non-read IRP

4EVENT_TIE_ACTIVITY_ID

\Segmenting L2CAP packet into HCI Packets

,Write HCI Packet

(Read HCI Packet

XBRB_L2CA_REGISTER_FIXED_CHANNEL_SERVER

\BRB_L2CA_UNREGISTER_FIXED_CHANNEL_SERVER

LBRB_L2CA_SEND_FIXED_CHANNEL_DATA

HBRB_L2CA_CONNECT_FIXED_CHANNEL

4RM_QUERY_RADIO_STATE

0RM_SET_RADIO_START

,RM_SET_RADIO_STOP

<RM_SET_DEVICE_POWER_START

<RM_SET_DEVICE_POWER_STOP

�A version 1.0B Bluetooth adapter was inserted into the computer, but this version is not supported.

|The address of the local Bluetooth adapter is not valid.

|A required feature (LMP) is not supported by the adapter.

�The Bluetooth driver expected an HCI event with a certain size but did not receive it.

�The address for the local adapter changed. The driver has unloaded from this device due to this error.

�The mutual authentication between the local Bluetooth adapter and a device with Bluetooth adapter address %2 failed.

�The local Bluetooth adapter has failed in an undetermined manner and will not be used. The driver has been unloaded.

HWindows detected an error while storing the Bluetooth link key for adapter address %2 on the local adapter. The event contains the vendor-specific error code.

HWindows detected an error while deleting the Bluetooth link key for adapter address %2 on the local adapter. The event contains the vendor-specific error code.

PYour Bluetooth device %2 attempted to establish a debug connection. The Windows Bluetooth stack does not allow debug connection while it is not in the debug mode.

The local adapter does not support a critical Low Energy controller state. The minimum required supported state mask is %2, got %3.

pThe local adapter does not support an important Low Energy controller state. The minimum required supported state mask is %2, got %3. Low Energy functionality will be disabled.

PThe Bluetooth controller or its firmware is incompatible with Windows. Please check Windows Update or your OEM website for an updated firmware or driver package.

�The device %2 is trying to distribute an Identity Resolving Key that is already used by a paired device. The pairing was rejected, if the intent was to pair with this device, you may need to first delete the existing pairing information.

�The device %2 is trying to distribute an Identity Address information that is already used by a paired device. The pairing was rejected, if the intent was to pair with this device, you may need to first delete the existing pairing information.

0Windows rejected a connection from your Bluetooth device %2 because the resulting encryption key size was smaller than the system required minimum.

LWindows rejected a legacy connection from your Bluetooth device %2 because the system is configured to not allow legacy connections by your system administrator.

(ACL_MODE_ACTIVE

$ACL_MODE_HOLD

(ACL_MODE_SNIFF

$ACL_MODE_PARK

4ACL_MODE_ENTER_ACTIVE

0ACL_MODE_ENTER_HOLD

4ACL_MODE_ENTER_SNIFF

0ACL_MODE_ENTER_PARK

,ACL_DISCONNECTED

8Sending packet to radio

@Packet received from radio

,Packet timed out

8L2CAP received a packet

DL2CAP is completing a packet

0Radio State Unknown

,Radio On Pending

Radio On

,Radio Off Pending

Radio Off

Unspecified

$S4-Hibernate

S5-Shutdown

�4VS_VERSION_INFO��
|O
|O?�StringFileInfo�040904B0LCompanyNameMicrosoft CorporationRFileDescriptionBluetooth Bus Driverh$FileVersion10.0.20348.1 (WinBuild.160101.0800)8InternalNamebthport.sys�.LegalCopyright� Microsoft Corporation. All rights reserved.HOriginalFilenamebthport.sys.muij%ProductNameMicrosoft� Windows� Operating System>
ProductVersion10.0.20348.1DVarFileInfo$Translation �PADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGXXPADDINGPADDINGX